# Septic Line Cleaning and Hydro Jetting in Denver

Hydro jetting cleans a septic line by driving water through a nozzle at high pressure, scouring grease and biomat off the pipe wall and cutting root mass rather than boring a hole through it. On a structurally sound septic line it is the most complete cleaning available, and on a failing one it is the wrong tool.

- High pressure cleaning of the building to tank line.
- Root cutting and full wall scour, not just a bored hole.
- Camera before and after, every time.
- Suitability judged by pipe condition, not by preference.
- Serving septic parcels across the Denver metro.

## When Is Jetting the Right Call on a Septic Line?

Jetting earns its place where the obstruction coats the pipe wall. Grease, soap scum, biomat, and fine root hair all build inward from the circumference, and a cable simply passes through the middle of that. Water at pressure takes it back to bare pipe.

It is also the right call where the line has been cabled repeatedly and keeps blocking. That pattern almost always means the material was never actually removed, only perforated. Either that, or there is a structural defect holding material in place, which the camera will show.

- Grease accumulation along a long building sewer run.
- Fine root mass at multiple joints.
- Biomat buildup in a line feeding a tank.
- Lines that block again weeks after cabling.
- Pre-repair cleaning so the camera can actually read the pipe.

## When Jetting Is the Wrong Tool

A jet nozzle applies real force to the pipe wall. On sound pipe that force does the work. On pipe that has already cracked, offset, or lost a section, that force finds the weakness. Jetting a failed line can turn a partial blockage into a full collapse.

That is not a reason to avoid jetting. It is the reason we camera first, every time, without exception. The camera tells us the material and the condition, and that determines whether the answer is a jet, a cable, or a repair.

- Cracked, sheared, or separated pipe sections.
- A collapsed run or a missing pipe segment.
- Severe deformation in Orangeburg or thin-wall material.
- A belly holding standing water that cleaning will not correct.

## How Septic Line Jetting Runs

1. **Open access and camera** Cleanout or tank inlet access, then a full camera run to read material, condition, and defect distance.
2. **Select nozzle and pressure** Nozzle choice and pressure are matched to the pipe material and to what is in the line, not set to one default.
3. **Jet the run** Work outward and pull back, scouring the wall and flushing the material to the access point rather than pushing it downstream into the tank.
4. **Camera again and report** A second run confirms bare pipe and documents any defect the buildup was hiding.

## What Drives Jetting Cost on a Septic Line

Run length, access, and severity set the price. A line with an accessible cleanout near the building is straightforward. A line where the only access is the tank inlet at depth adds excavation before any cleaning starts.

If the post-clean camera shows a defect that will re-block the line, we tell you what it will take to fix and we do not pretend the cleaning solved it.

Call (720) 935-6221 to book a scope and clean.

## Frequently asked questions

**Will hydro jetting damage my septic line?**

Not on sound pipe. On pipe that has already failed structurally, it can, which is exactly why we run a camera before the nozzle goes in. If the line cannot take the pressure safely we do not jet it, and we tell you what the alternative is.

**How is jetting different from snaking?**

A cable bores a channel through the obstruction. Jetting removes the obstruction from the pipe wall. On grease and biomat that difference is the whole result, because material left on the wall closes the bored channel again quickly.

**Where does the material go when you jet?**

Back toward the access point, where it is removed. Jetting properly means pulling material back, not driving it downstream into the septic tank where it becomes the tank's problem.

**My line blocked again a month after jetting. What now?**

That means there is a defect holding material, most often a belly, an offset joint, or a root entry point that reopens. The post-clean camera run usually shows it. The next step is repair of the defect rather than another clean.

**Are you Denver Water or the city?**

No. Denver Sewer and Water is a private, family owned and operated company. We are not Denver Water or the City and County of Denver. A septic system is privately owned infrastructure, and we are the contractor a property owner hires to work on one.

## Related Septic Services

- [Septic Systems in Denver](https://www.denversewerandwater.com/septic-systems/denver-co) The full septic lane: diagnosis, repair, replacement, and the excavation behind it.
- [Septic System Cleaning](https://www.denversewerandwater.com/septic-systems/septic-system-cleaning) Clearing the lines and components that pumping alone does not reach.
- [Septic System Video Inspection](https://www.denversewerandwater.com/septic-systems/septic-system-video-inspection) Camera work on the building sewer and the tank inlet before anyone quotes a dig.
- [Trenchless Septic System Repair](https://www.denversewerandwater.com/septic-systems/trenchless-septic-system-repair) Rehabilitating septic line runs from access pits instead of open trench.

---

Denver Sewer and Water is a privately owned, licensed and insured plumbing contractor. We are not affiliated with, endorsed by, or connected to Denver Water, the municipal water utility, or any government entity. To pay a municipal water bill or reach the public utility, visit denverwater.org.

Source: https://www.denversewerandwater.com/septic-systems/septic-line-cleaning-hydro-jetting